Research Article | | Peer-Reviewed

An Empirical Analysis of Capacity Utilization and Total Factor Productivity to Inference on Technical Efficiency Level of Tunisian Manufacturing Industry

Received: 22 August 2023     Accepted: 20 September 2023     Published: 26 December 2023
Views:       Downloads:
Abstract

In this article, we tried to examine the various definitions stated in the literature about the performance and measurement of the capacity utilization rate, the total factor productivity and the technical efficiency. This study stresses two basic points. On the one hand, it gives an idea about the state of the Tunisian manufacturing industry of which it is essential to define the relevant guidance of such economic policy. On the other hand, it presents the stochastic methods, which are able to integrate the multifactor productivity in the cost model, and then the measurement of technical efficiency and the capacity utilization. Our results show that, despite the technological progress, there is a decline in productivity growth over the 1961/2014 period due to the growing inefficiency. The under-use of production capacity in the different sectors of the Tunisian manufacturing industry was considered a consequence of the excess capacity and the lack of efficiency attributed mainly to the lack of competition, which enables farms to operate below their frontier if they are protected on the market.

Published in Journal of World Economic Research (Volume 12, Issue 2)
DOI 10.11648/j.jwer.20231202.14
Page(s) 81-98
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2023. Published by Science Publishing Group

Keywords

Capacity Utilization, Total Factor Productivity, Substitution Elasticity, Technical Efficiency, Tunisian Manufacturing Sectors

References
[1] Achy, L., 2011. Tunisia’s Economic Challenges. Carnegie Middle East Center, December.
[2] AfDB/MCC/MDCI, 2013. Towards a New Economic Model for Tunisia, Identifying Tunisia’s Binding Constraints to Broad Based Growth. Joint Study by the African Development Bank, the Government of Tunisia, and the Government of the United States (Millennium Challenge Corporation).
[3] Aigner, D. J., Lovell C. A. K., and Schmidt P., 1977. Formulation and Estimation of Stochastic Frontier: Production Models. Journal of Econometrics, 6, 21-37.
[4] Baldwin, John R., Wulong G., and Beiling Y., 2013. Export Growth, Capacity Utilization, and Productivity Growth: Evidence from the Canadian Manufacturing Plants. Review of Income and Wealth, 59 (4), 665-688, December.
[5] Berndt, R. E., and Catherine J. M., 1981. Capacity utilization measures: Underlying Economic Theory and an Alternative Approach. American Economic Review, 71, 48-52.
[6] Berndt, R. E., and Fuss M. A., 1986. Productivity measurement with adjustment for variations in capacity utilization and other forms of temporary equilibrium. Journal of Econometrics, 33 (1), 7-29.
[7] Berndt, R. E., and Fuss M. A., 1989. Economic capacity utilization and productivity measurement for multiproduct firms with multiple quasi-fixed inputs. National Bureau of Economic Research Working Paper No. 2932. Cambridge, Massachusetts, USA, National Bureau of Economic Research.
[8] Cassels, J. M., 1937. Excess Capacity and Monopolistic Competition. Quarterly Journal of Economics, 51, 426-443.
[9] Corrado, C., and Mattey J., 1997. Capacity Utilization. Journal of Economic Perspectives, 11 (1), 151-167.
[10] Diewert, W. E., 1974. Functional Forms for Revenue and Factor Requirements Functions. International Economic Review, 15 (1), 119-130.
[11] Diewert, W. E., and Fox J. K., 2008. On the estimation of returns to scale, technical progress and monopolistic mark-ups. Journal of Econometrics, 145 (1-2), 174-193, July.
[12] Farrell, M. J., 1957. The Measurement of Productive Efficiency. Journal of the Royal Statistical Society, Series A, 120 (3), 253-290.
[13] Friedmann, G., 1963. Où va le travail humain?. Revue Française de Sociologie, 4(3), 359.
[14] Gu, W., and Wang, W., 2013. Productivity Growth and Capacity Utilization. Statistics Canada Catalogue no. 11F0027M. Ottawa, Ontario. Economic Analysis (EA) Research Paper Series. No. 085.
[15] Helali, K., and Kalai M., 2015. Technical efficiency determinants of the Tunisian manufacturing industry: Stochastic production frontiers estimates on panel data. Journal of Economic Development, 40(2), 105-130, June 2015. http://www.jed.or.kr/full-text/40-2/5.pdf.
[16] Helali, K., Kalai M., and Siala M., 2016. Estimation comparison of the capacity utilization at constant and non-constant returns to scale: the case of the Tunisian manufacturing sector. International Journal of Computational Economics and Econometrics, 6 (1), 56-70.
[17] Hickman, B. G., 1964. A New Method of Capacity Estimation. Journal of the American Statistical Association, 59, 529-549.
[18] Hsieh, Ch. T., and Klenow P. J., 2009. Misallocation and Manufacturing TFP in China and India. The Quarterly Journal of Economics CXXIV (November 2009 Issue 4).
[19] Jondrow, J., Lovell C. A. K., Materov U. S., and Schmidt P., 1982. On the estimation of technical inefficiency in the stochastic frontier production function model. Journal of Econometrics, 19, 233-238. North-Holland Publishing Company.
[20] Jouini, E., 2014. Tunisie L'espoir: mode d'emploi pour une reprise. Tunis: Cérès éditions.
[21] Kalai, M., and Helali, K., 2021. Non-Parametric Developments and Analyses of the Capacity Utilization, Technical Efficiency and Total Factor Productivity: Applications to the different Sectors of the Tunisian Manufacturing Industry. Lambert Academic Publishing. ISBN: 978-620-3-58253-6.
[22] Klein, R. L., 1960. Some Theoretical Issues in the Measurement of Capacity. Econometrica, 28, 272-286.
[23] Klein, R. L., and Preston S. R., 1967. Somme new results in the measurement of capacity utilization. American Economic Review, 57 (1), 34-58.
[24] Lau, L. J., 1976. A Characterization of the Normalized Restricted Profit Function. Journal of Economic Theory, 12, 131-163.
[25] Lau, L. J., 1978. Applications of profit functions. In Melvyn Fuss and Daniel McFadden. Production economics: a dual approach to theory and applications. North-Holland publishing company: Amsterdam, 1, 133-216.
[26] McFadden, D. L., 1973. Cost, Revenue and Profit Functions. In D. L. McFadden edition, An Econometric Approach to Production Theory (Amsterdam: North-Holland Publishing Co.).
[27] McMillan, M., and Dani R., 2011. Globalization, Structural Change, and Productivity Growth. NBER Working Paper 17143, National Bureau of Economic Research, Cambridge MA.
[28] Meddeb, R., 2011. Ensemble: construisons la Tunisie de demain, Modernité, solidarité et performance, Octobre 2011. Action et Développement Solidaire, Tunis.
[29] Morrison, J. C., 1982. Three Essays on the Dynamic Analysis of Demand for Factors of Production. Unpublished Ph. D. Dissertation, University of British Columbia, Department of Economics.
[30] Morrison, J. C., 1986. Productivity Measurement with Non-Static Expectations and Varying Capacity Utilization. Journal of Econometrics, 33 (1-2), 51-74.
[31] Morrison, J. C., 1988. Quasi-fixed inputs in US and Japan manufacturing: A generalized Leontief restricted cost function approach. The Review of Economics and Statistics, 70, 275-287.
[32] Ohta, M., 1974. A Note on the Duality Between Production and Cost Functions: Rate of Returns to Scale and Rate of Technical Progress. Economic Studies Quarterly, 25, 63-65.
[33] Schmidt, P., and Lovell C. A. K., 1979. Estimating Technical and Allocative Inefficiency Relative to Stochastic Production and Cost Frontiers. Journal of Econometrics, 9, 343-366.
[34] Solow, M. R., 1956. A Contribution to the Theory of Economic Growth. Quarterly Journal of Economics, 70 (1), 65-94.
[35] Solow, M. R., 1957. Technical Change and the Aggregate Production Function. Review of Economics and Statistics, 39 (3), 312-320.
[36] Swan, T. W., 1956. Economic Growth and Capital Accumulation. Economic Record, 32 (2), 334-61.
[37] Tipper, A., and Warmke N., 2012. Adjusting productivity statistics for variable capacity utilisation. Working harder or hardly working? Statistics New Zealand Working Paper, no. 12-02.
[38] World Bank, 2014. La Révolution Inachevée: Créer des opportunités, des emplois de qualité et de la richesse pour tous les Tunisiens, TUNISIE: Revue des politiques de développement, Rapport No. 86179-TN, May 2014.
[39] Zellner, A., 1962. An efficient method of estimating seemingly unrelated regression and tests for aggregation bias. Journal of the American Statistical Association, 57 (298), 348-68.
Cite This Article
  • APA Style

    Kalai, M. (2023). An Empirical Analysis of Capacity Utilization and Total Factor Productivity to Inference on Technical Efficiency Level of Tunisian Manufacturing Industry. Journal of World Economic Research, 12(2), 81-98. https://doi.org/10.11648/j.jwer.20231202.14

    Copy | Download

    ACS Style

    Kalai, M. An Empirical Analysis of Capacity Utilization and Total Factor Productivity to Inference on Technical Efficiency Level of Tunisian Manufacturing Industry. J. World Econ. Res. 2023, 12(2), 81-98. doi: 10.11648/j.jwer.20231202.14

    Copy | Download

    AMA Style

    Kalai M. An Empirical Analysis of Capacity Utilization and Total Factor Productivity to Inference on Technical Efficiency Level of Tunisian Manufacturing Industry. J World Econ Res. 2023;12(2):81-98. doi: 10.11648/j.jwer.20231202.14

    Copy | Download

  • @article{10.11648/j.jwer.20231202.14,
      author = {Maha Kalai},
      title = {An Empirical Analysis of Capacity Utilization and Total Factor Productivity to Inference on Technical Efficiency Level of Tunisian Manufacturing Industry},
      journal = {Journal of World Economic Research},
      volume = {12},
      number = {2},
      pages = {81-98},
      doi = {10.11648/j.jwer.20231202.14},
      url = {https://doi.org/10.11648/j.jwer.20231202.14},
      eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.jwer.20231202.14},
      abstract = {In this article, we tried to examine the various definitions stated in the literature about the performance and measurement of the capacity utilization rate, the total factor productivity and the technical efficiency. This study stresses two basic points. On the one hand, it gives an idea about the state of the Tunisian manufacturing industry of which it is essential to define the relevant guidance of such economic policy. On the other hand, it presents the stochastic methods, which are able to integrate the multifactor productivity in the cost model, and then the measurement of technical efficiency and the capacity utilization. Our results show that, despite the technological progress, there is a decline in productivity growth over the 1961/2014 period due to the growing inefficiency. The under-use of production capacity in the different sectors of the Tunisian manufacturing industry was considered a consequence of the excess capacity and the lack of efficiency attributed mainly to the lack of competition, which enables farms to operate below their frontier if they are protected on the market.
    },
     year = {2023}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - An Empirical Analysis of Capacity Utilization and Total Factor Productivity to Inference on Technical Efficiency Level of Tunisian Manufacturing Industry
    AU  - Maha Kalai
    Y1  - 2023/12/26
    PY  - 2023
    N1  - https://doi.org/10.11648/j.jwer.20231202.14
    DO  - 10.11648/j.jwer.20231202.14
    T2  - Journal of World Economic Research
    JF  - Journal of World Economic Research
    JO  - Journal of World Economic Research
    SP  - 81
    EP  - 98
    PB  - Science Publishing Group
    SN  - 2328-7748
    UR  - https://doi.org/10.11648/j.jwer.20231202.14
    AB  - In this article, we tried to examine the various definitions stated in the literature about the performance and measurement of the capacity utilization rate, the total factor productivity and the technical efficiency. This study stresses two basic points. On the one hand, it gives an idea about the state of the Tunisian manufacturing industry of which it is essential to define the relevant guidance of such economic policy. On the other hand, it presents the stochastic methods, which are able to integrate the multifactor productivity in the cost model, and then the measurement of technical efficiency and the capacity utilization. Our results show that, despite the technological progress, there is a decline in productivity growth over the 1961/2014 period due to the growing inefficiency. The under-use of production capacity in the different sectors of the Tunisian manufacturing industry was considered a consequence of the excess capacity and the lack of efficiency attributed mainly to the lack of competition, which enables farms to operate below their frontier if they are protected on the market.
    
    VL  - 12
    IS  - 2
    ER  - 

    Copy | Download

Author Information
  • Faculty of Economics and Management of Sfax, University of Sfax, Sfax, Tunisia

  • Sections